Building a hypercoaster in RCT

The Station, Testing & Tweaking

Now that you have the coaster built, it's time to add the entrance(s), exit(s), and paths, and test the ride. If you are using a money-based scenario, remember that hypercoasters are expensive to build, but you can charge a lot for them.


Sky Devil has no inversions, like most hypercoasters. Use non-looping trains to increase excitement dramatically.


Once the ride is built, it must be tested. This is the launched lift hill.


However, the chain lift top keeps the speed down to 5mph at the top of the ride.


The train goes quickly into section 2, which is why it needs to be wide radius curves.


OK, maybe the ride is too long. The train is going rather slow now.


Yes, it it too slow, as the train is about to fall back. I think boosters are needed here. The best place for them is underground, as they don't look good. Hmm – Iceworld tunnels perhaps.


The first booster, set to maximum speed (also max acceleration). Basically any flat straight track after this was suitable for boosters.


Like the straight between these down & up helixes,


Or this tunnel exit, and the section where the train actually stops.


There is also no problem with a launched lift hill from under the donut stall.

Retesting


That speed is better, and now the train makes it back to the station. There is usually something you need to correct on a coaster to make it work as planned.


See? This is after the point where it stopped first time.

Notes

Here are a few general points to remember:

  • Boosters don't look good. If you use them, try to put them underground or behind scenery.

  • Don't rely on brakes too much or you will have station brakes faliures. Likewise note that lift hills can fail. Make sure this won't cause a crash.

  • Take curves at a reasonable speed. If they are too fast, intensity goes up. Too slow and it becomes boring.


Approaching the station slowly reduces intensity on the brakes (to 5mph) and reduces wear, which is what often causes the brakes to fail. All that's needed now is a suitable colour scheme and a name for the ride.


Sky Devil may be 4ft off hypercoaster status, but I personally don't care. It'll do for me ;) .

Back to Section 3: Completing The Circuit

Back to The Introduction


This site © rcthelp 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009 and © sambo 2004, 2005, 2006, 2007, 2008, 2009. Rollercoaster Tycoon™, Rollercoaster Tycoon 2™ and various images on this site are © Hasbro Interactive, Infogrames Inc, Atari Inc and Chris Sawyer. Designed for screen resolutions of 800*600 or above and 16-bit colour. To get the best from the site, please configure your browser to accept cookies and run Javascript. You can read our Privacy Policy by clicking here, and our Terms of Service here. Contact webmaster@rct2.com for questions or other enquiries about this site.